This VVDI2 Version comes with Basic Function + VW + BMW + Porsche+PSA+ AUDI Generation 5 Function+BMW OBD Fucntion+BMW CAS4+ Functions +Tango + J2534.
VVDI2 Covers All the Functions of VVDI, VVDI 5th IMMO Adapter, BMW Multi Tool, CAS4 Adapter, Tango & J2534.
Original Xhorse VVDI2 Commander Key Programmer
Top 5 Reasons to Get VVDI2:
1. This VVDI2 comes with Basic Function + VW + BMW + Porsche+ AUDI Generation 5 function + BMW OBD Function + BMW CAS4 + function + Tango + J2534 , No Need to buy other Authorization
3. Support VW, Audi, BMW and Porsche & PSA
4. Newest Version: V7.2.2 , Update Free all Lifetime
5. VAG EDC17 PIN, MAC, CS calculation via eeprom and flash dump (the function can be activated even without having condor key cutter), please provide VVDI2 serial number to activate
This VVDI2 Version with Activated Software List as below:
1) VV-01 VAG 4th immobilizer
2) VV-02 VAG 5th immobilizer
3) VV-04 ID48 96Bit Copy
4) VV-05 VAG MQB Immobilizer
5) VB-01 BMW OBD
6) VB-02 BMW CAS4
7) VP-01 Porsche immo data tool
8) VPSA-01 PSA
9) VK-01 Transponder Programmer
10) VJ-01 Passthru J2534
Notice: No VV-03 VAG Copy 48 transponder by OBDII and VB-03 FEM/BDC Function in this package.
VVDI2 - BMW FEM/BDC System (function released and available, just no user manual)
Users can refer to following information (3 steps for make keys: get key info->programming FEM/BDC system->make keys)
1. Support make new key with ignition switch(support add spare key and all key lost, all key lost require ISN)
2. Support reset FEM/BDC KM (cluster require reset manually)
3. Support erase key (after erase the key position become blank position)
4. Support backup coding
5. Support restore coding
Note:
1. Backup coding and restore coding can direct operation generally.
2. Add keys, reset KM, erase key must programming FEM/BDC system first
3. In FEM/BDC interface, if 'get key info' the type not support, it will show: customer should use "BMW E-sys software" program FEM/BDC system. then programming FEM/BDC system with VVDI2-BMW
4. When operation on 'programming FEM/BDC system'interface, please don't close this software window until all procedures completed.
5. Programming FEM/BDC system, require soldering and get eeprom. (FEM 95128 chip, BDC 95256 chip)usually there are 2 same chips on the module, please refer to the software diagram, select the correct one.
6. Programming FEM/BDC system, must restore the original eeprom, restore coding. if cannot restore coding or after restore coding assemble FEM/BDC module back to car, but with problem(such as the remote control cannot start the car
or the car with window problem)please use "BMW E-sys software" coding for FEM/BDC system
7. If connect power to FEM/BDC module, but the relay keep ringing, please contact technical support for help.usually operation on FEM/BDC should be ok, just need to programming.
