Newsletter
How to abnormal conductivity detect for Xhorse Dolphin XP005 probe and milling cutter
We got a customer feedback us for the Xhorse Dolphin XP005:
Xhorse Dolphin XP005 key cutter makes strange noises at the beginning and end of work, the key that is cut also not flat.
We have sent to Xhosre engineers checked and they give the solution:
Turn on the machine and clean it up, and add some lubricating oil to the screw andand guide rail.
Here you go for the operation guide:
Step1: Disassemble the back cover, and be careful of the wiring harness of the cover when disassembling
Step2: Remove the back cover, you can see these things, take off the wire harness, and remove the Phillips screws (see Figure 1). Take out the rubber pellets from the front of the Dolphin XP005. There are screws inside. This strip needs to be removed (Figure 2)
Figure 1
Figure 2
Step3: Use a flat-blade screwdriver to turn the lead screw, align the Z-axis and the outer cover on a horizontal surface (as shown in Figure 3 and Figure 4), remove the Z-axis housing after alignment (as shown in Figure 5), and place the probe next to it. Remove the screws (as shown in Figure 6). Remember to be careful when removing it. There is a conductive wire inside (as shown in Figure 7).
Figure 3
Figure 4
Figure 4
Figure 5
Figure 6
Figure7
Step4: If the above steps are all done, the next step is to check whether the conductive wires of the milling cutter and the probe are conductive or short (as shown in Figure 5 and Figure 7), which needs to be combined with the main board to detect. (Figure 8) (or plug in the cable on the main board, and then check whether the conductivity is normal)
Figure 8
Step5(conductivity of cutter): Loosen the 3 screws of the Z axis (as shown in Figure 9), and then tighten the two screws (as shown in Figure 10). Push these two screws to the inside until there is a gap. This is to take out the shaft (as shown in Figure 11), press your finger on the position of the milling cutter hole, and push it up with a little force. Come up, and then observe whether the white paper inside is broken (as shown in Figure 12), if it is broken, it needs to be replaced. If it is not broken, observe whether there is iron filings in the bearing hole
Figure 9
Figure 10
Figure 11
Figure 12
For Xhorse Dolphin XP005 Tech support check :
https://www.obd2shop.co.uk/wholesale/xhorse-new-condor-dolphin-key-cutting-machine.html
Hope it helps.
Any questions, feel free contact us.
Obd2shop.co.uk customer service